up to 650°C / 1,200°F

Exhaust Header Wrap can lower under bonnet temperatures by as much as 70%. Lowering under bonnet temperatures mean lower intake temperatures, that means more horsepower and better fuel efficiency. By wrapping your exhaust will maintains hotter exhaust gases, decreases the gas density, and that allows the exhaust gas to exit the system faster! Increased exhaust scavenging is produced helping to lower intake temperatures by literally pulling them through the cycle faster: that equals to more horsepower. Exhaust Header Wrap can also help to keep heat out of the drivers compartment and reduces heat damage to other components. Our Exhaust Header Wrap features a texturized vermiculite coating which makes it capable of withstanding heat up to 650°C / 1,200°F continuous and 1,093°C / 2,000°F intermittent. Wrap around or "coil" the Exhaust Header Wrap around your exhaust pipe, using a overlap to hold itself in place use our Stainless Steel Ties, hose clamps, or stainless steel wire to secure ends in place.


Our Exhaust Header Wrap is asbestos free and is made from a base high quality fiberglass yarn. It is also water and fungus resistant. Always wear gloves, safety glasses and dust mask when handling this product, long sleeves are also recommended.

   

  • Rated up to 650°C / 1,200°F continuous and 1,093°C / 2,000°F intermittent
  • Exhaust header wrap reduces under bonnet temperatures by up to 70%
  • Exhaust header wrap Increases horsepower / kilowatts
  • All rolls of Exhaust Header Wrap are 1.6mm thick, ( Thicker Thicknesses are available on request )
  • Always wear safety glasses, dust mask, gloves and long sleeves are recommended when handling Exhaust Header Wrap
  • Exhaust Header Wrap is made in the USA
  • This product is available in:- 25mm = 1" or 50mm = 2" ( Wider Wraps are available on request ).

 

Our standard roll lengths are: -
7.5m or 25ft lengths
15m or 50ft lengths
30m or 100ft lengths

Exhaust Header Wrap is currently available in 2 different colors: - Black or Tan.

The Preferred Exhaust Header Wrap Overlap is 6mm is recommended for high performance and racing applications, a 50% overlap is recommended for most stock applications.

2 Item(s)

per page

2 Item(s)

per page